With the lights set to "left" the beam pattern should be flat on the right side with a diagonal kick-up to the left. This is the correct setting for the UK and Ireland as the kickup lights up road signs etc on the side of the road while the flat part on the right avoids dazzling oncoming traffic. I have shared the problem of focus of the headlamps. Please check the video to get some idea of how to fix this common issue.headlightheadlightsled headlight Put a blanket or an item of clothing over the headlight you aren’t adjusting. Turn the lights off and use a screwdriver to turn the screws until the headlight is at the level you require. Turn your headlights back on to see if further adjustment is required. There should be a screw to adjust the lamp vertically and another screw to align it 2015 - 2020 Ford F150 - Auto Headlight Sensor Adjustment - I know this was discussed a while back, but has anyone found a way to adjust the tolerances yet. I know you can adjust the delay in Forscan, but it's like to adjust the light tolerances. Unless the sensor is in direct sun, the headlights kick on. HOW TO CHANGE A HEADLIGHT IN 5 MIN - Ford Focus ST Front headlight. Ford focus headlight & assembly change 2017- same for many years. Car styling led for ford focus headlights 2012 2014 tlz focus 3 led Headlight adjustment. Turn the headlights ON and mark the wall at the center of each light's low beam, then switch on the brights and mark the center of each light's high beam. A short length of masking tape which is visible from the front of the vehicle may be used. Although marking all four positions is advisable, marking one position from each light should be Adjust the Aims with the Markings on the Wall as a Guide. Now that you’ve distanced the truck and located the adjusters, you can now adjust the headlight aim. First, block a single headlight and see where the other beam reflects relative to the lines you’ve drawn on the vertical surface. For vertical aim, the upper part of the beam’s most For the rest of the procedure here are the steps to stick to: Open your bonnet, find the screws for horizontal and vertical modification of the headlights of your Ford Focus C-max (they are generally designated, and those on top must adjust the verticality and the one on the side manages the horizontality of the adjustment). If you are buying our headlamp converters from http://www.headlampconverters.co.uk/How-fit this video may help.Can I just point out that this video was made The headlight adjustment of his Ford E Series. Once your vehicle is in place, you will turn on your dipped beam and make a cross-shaped mark (one horizontal and one vertical section) in the middle of the beam that will be projected on the wall. Verify with a level that both parts of the cross are horizontal. Then back your car up to a distance zxuE.